CyberHooves

Just add pineapple.

Which backrooms level is that?

Thought it was (in furry art at least) a terminology thing where peets are plantigrade and pawbs are digitigrade?

If you stare into the void long enough, the void stares back at you.

Front Page ReactOS is a free, opensource reimplementation of windows

reactos.org

Oh wow they must feel amazing to wear! 💓

Love the transparent flip-flops <3

Furry liminal space.

How else are you supposed to make scrambled coffee?

n00b question, but is this model game ready?

Scarousing <3

Got milk?

"My fursona isn't that edgy!"

Starting on the teeth - these are at the "plastic booger" stage and are mashed out of mouldphorm plastic. Need to reheat them to form them into their final shape.

Furry liminal space.

They are clearly less than five feet apart. Discuss.

YouTube video by PureKoor Is AI Art Ruining Fandom Artists? ➡ TLDR

AI Art has been discussed endlessly...and poorly... so I condensed the topic to address the real problems. Let's discuss...
youtu.be/8tGnVWjI-z4

#furry #furryart #video #AI #AIArt #VTuber #youtube

Today I had the privilege of an on-site visit to the EISCAT Svalbard radar for ionospheric and atmospheric research. Was awesome to see it up close!

Lots of last minute organising, so didn't think I'd get permission or ability to do this! 😄

THE DOOR IS STUCK!

Is... is that a cacodemon?

Thanks, it did bite my hand quite hard :)

Jaw test at about 6bar or 90psi air pressure. I think it needs a flow regulator x.x

Now with the cable gland holes done, it's on to the final two horns - this pattern is made from a fence wire skeleton filled with modelling foam and low-melt plastic and will be removed once a fibreglass shell has been built over it.

Overall, with the right putty, this works well for larger non-structural threads. For smaller threads, self-tapping screws or suitable threaded inserts may be better options. 7/7

Inside view showing the bolts poking through 6/7

Glands are in! They weren't used to cast the threads themselves, as the threads are too short, and would likely have broken when being removed. 5/7

Once cured, the screws and washers can be removed, and the back side tidied using a die grinder. A chisel and a file were used to remove a few burrs from the front side.

Then set the screws using blobs of plasticine to hold them in place. The putty was made from laminating resin with fumed silica as a thickener, and milled carbon fibre as a strengthener, so the hardened putty can hold a thread. 3/7

First, apply wax to steel fasteners with the same thread as the glands, in this case M12x1.5 - the wax prevents the epoxy from adhering to the threads. Also pictured are four polypropylene washers to create a flat outside surface. Regular steel washers can be used if waxed as well.

Needed to fit cable glands to my head, but couldn't use the backnuts as there wasn't enough room and the internal surface is uneven. Instead, we're going to cast the threads using epoxy putty - this should make threads strong enough for non-structural applications like this, more below. 1/7