Polling Stones
The Barkness
The Dangles
Kazoo
2p's worth. If it'savailable , try and get the NSAWC A/B version. You get the option of either a 1 or 2 seater, cool scheme and a vast amount of weapons. But, its an early A/B with NSI and a PW engine/nozzle only.
Not got my hands on any of their Gold Series yet. The 'original' boxings are pretty decent , once you know the known issues and limitations. Plus you'll get a vast array of underwing stores, most if which you'll consign to spares drawer.
Q for the sale model car makers, where do you source replacement decals?
Finito
From memory it's usually on the clear sprue in airfix kits and it's a 2 part ( one clear one plastic) on the revell
There are several airfix kits that have the Hs2, some lancs, think there's a Halifax too. Might have one in a spares stash if needed?
A very good stir and a drop more of thinner. I use a pipette to drop specific amounts in each pot. I've also added ball bearings to each pot. Helps break up any congealed pigment that occurs between builds.
I pre-thinned the 3 main colours as I build a lot of bundeswehr vehicles (40+) so far. Made sense to me.
Front, I used revell aquacolours over the top of rattle can mid-grey primer. All 3 camo colours are thinned, in pot, with revell airbrush thinner. Mixed thoroughly and applied with a number 2 brush. All over green then apply black then brown. Touched as required due to missing bits or handling.
All done. 2x Patriots and tractor.
Now for the 400 decals on the F-4F Phantom.
An empty tidy desk is the sign of a warped mind
More work done on the trailer
MIM-104F build progress. Fiddly nylon wiring attached to launcher tubes. Will leave until full cured then attach them, with extreme care, to the launch base.
Any TOAW IV players on here?
Any TOAW IV players here fancy a match?
Both together for the 1st time
This is going nato 3tone european as per the box. May have to make a mask for the 4 launch tubes
Decided to strip the original paint as it dried very streaky. Repainted with a fresh pot of XF53, much nicer finish and lighter dried colour. Onto the tyres
Do both
Yesterday's work, around 3 hours.
Waiting for paint, thought id start this. Goes with a 104B launcher
Note to self, ensure you have enough paint before starting!
Worra muppet!
Plasticaholics?
Lots of modellers here, just trying to find them
My Twin? Thompson
Middle circle, blimey need to get off here and model more
And where we are now, in terms of sub assemblies, we're almost complete. Primered these after these pics were taken.
Made a start on this today and it's going to be emotional.
Oh, and it was electric too. That'll teach him to wear socks in his loafers on a cold wet day
