Made with Layers

I found it pretty interesting that my results for rigidity still varied that much between manufactures today. Still, I'd definitely set up the testing differenty if I were to run the series again!
Agreed on rigid ink, they made some great filament.

..and why is the answer "it depends"? 😁 Thanks to #UGREEN for sponsoring a part of this video! Check out the #UGREENNAS DXP4800 Plus and their Prime Day collection direct from UGREEN (US)… Why Are 3D Printers Still Using ANCIENT Motors?

BLDC servos are smaller and more powerful than steppers - then why aren't we using them everywhere?

Thanks to PCBWay for sponsoring a part of this video! Easily order PCB(A)s, 3D prints and CNC machined and sheet metal parts at https://pcbway.com PPS-CF and PPA-CF have seen a lot of hype - but is… The cheapest filament is the BEST for this part?

It's not the stiffness that matters, it's how you use it
www.youtube.com/watch?v=pC33...

Get the Q2: https://go.toms3d.org/qidiq2 Models shown: Mini Ghost https://makerworld.com/en/models/1712458-mini-ghost Steamfeather… Wannabe or Klipper-based powerhouse? "It's complicated 💀" with the Qidi Q2.

Relationship status: It's complicated 💀
www.youtube.com/watch?v=30gz...

It's that realization of "wait, THIS is what I could have had all along?"
I've always been into 3D printing because I enjoyed seeing the technological progress that was being made, and right now, Bambu Corp. is where that progress is happening.

Bambu are in a league of their own - and they just keep winning Thanks to VoxelPLA for sponsoring this project! Check out their filaments and accessories at https://voxelpla.com/madewithlayers Get… Testing Bambu’s BIGGEST 3D Printer - the H2S!

Big printer. Very impressive.
www.youtube.com/watch?v=sbL5...

Thanks! There's so much more to come here, I was really struggling to keep the video short 😅

I loved building Caroline, hope it shows in the video! Thanks to VoxelPLA for sponsoring this project! Check out their filaments and accessories at https://voxelpla.com/madewithlayers CNC Kitchen… Meet Caroline: Testing ways to build a cheap Robot Arm (for science!)

Yes, I'm still alive (and the cake was fantastic)!
Meet Caroline, my experimental low-cost robot arm - swinging a camera today, on the way to running my Studio tomorrow.
www.youtube.com/watch?v=rKyJ...

Main Stage building!

If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉

(Creator Museum is to the right as you walk into the main stage building)

If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉

(Creator Museum is to the right as you walk into the main stage building)

Yes! Has been running all day and is currently taking a well-deserved nap, but I'll start it back up first thing in the morning!

Found some lovely people at Open Sauce that could give my little robot project a ride to the creator museum 🤩

Ready for packaging (minus a few details)
Let's hope she survives the flight!

YouTube video by Made with Layers (Thomas Sanladerer) Could this be the new 4-color Ender-3? Anycubic Kobra 3 v2 (Combo)

Basically, a modern-day Ender-3
youtu.be/xjQzALNuwCM

I'm building a little something to bring to OpenSauce 🍰

Handle secured.