Mike Long

Cherry and poplar hutch. 60”x73”x22”. #woodworking More at www.instagram.com/p/DN8s6cJAUd...

29.08.2025 18:19 — 👍 2    🔁 0    💬 0    📌 0

Tim Manney design shave horse. #woodworking

08.03.2025 18:07 — 👍 12    🔁 0    💬 0    📌 0

cool! post when done!

06.02.2025 15:39 — 👍 1    🔁 0    💬 0    📌 0

I've been thinking about that joint more... if you have machines, you could probably make an accurate shooting board and plane down to a scribed line. way more accessible than a miter jack and would allow for a reproducible long miter

06.02.2025 04:42 — 👍 1    🔁 0    💬 1    📌 0

Miter jack vises are dinosaurs… red rose makes but them very expensive new. Mine is a very lucky antique find. Mitered dovetails I’m familiar with are thru cut. There’s a good fww article in the archive on them

06.02.2025 01:17 — 👍 0    🔁 0    💬 2    📌 0

I think it's a tough joint by hand; lots lot of end grain glue surface which would leave it weak. But, I've done long 45 degree angles using a miter jack vise before. If I tackled this joint I'd probably cut the rabbet first then would take down the 45deg side. Consider mitered dovetail corners?

05.02.2025 23:24 — 👍 1    🔁 0    💬 1    📌 0

25.01.2025 16:21 — 👍 4    🔁 0    💬 0    📌 0